Avocent DSView Installer/User Manual page 92

72 DSView 3 Software Installer/User Guide
transmitting data. This SSL method provides medium security and automatically sets the
Port Number field to a default port number of 636.
This encryption mode is not recommended for wide area networks (WANs).
• Click Use SSL in Certificate-based Trust Mode to use SSL encryption for data
transmission. The DSView 3 software will approve the server and then the certificate
before transmitting data. This SSL method provides maximum security and automatically
sets the Port Number field to a default port number of 636.
9. Click Save to save your changes.
If you selected Use SSL in Certificate-based Trust Mode, the Certificates heading will appear
in the side navigation bar. Go to step 8.
If you selected Do Not Use SSL or Use SSL in Trust All Mode, go to step 15.
10. Click Certificates. The Authentication Service Certificate Management - LDAP window will
open and list all servers that belong to the domain. A status of Trusted indicates the certificate
is trusted, based on the certificate policy (see System certificate policy and trust store on
page 26); Untrusted indicates the certificate cannot be trusted.
11. To register certificates, click the checkbox to the left of the server IP address(es). To select all
server IP addresses on the page, click the checkbox to the left of the IP Address heading.
12. Click Register to register the certificates. The Accept SSL Certificate window will appear.
13. Click Save to store the certificate values to the DSView 3 software database on the host.
The Certificate Management window will open if only one certificate was selected. If more
than one certificate was selected, each will appear in order in subsequent Accept SSL
Certificate windows.
14. To unregister one or more certificates, check the checkbox to the left of the server IP
address(es). To select all server IP addresses on the page, click the checkbox to the left of the
IP Address heading.
15. Click Unregister to unregister the certificates.
16. A confirmation message box will appear. Confirm or cancel the operation.
17. Click Close. The User Authentication Services window will open.
To change user schema settings for the LDAP external authentication service:
1. Click the Users tab.
2. Click Authentication Services in the top navigation bar. The User Authentication Services
window will open.
3. Click the name of the LDAP service. The side navigation bar will change to include the name
of the LDAP service at the top and, below the name, the information you may define.
4. Click Schema in the side navigation bar. Users will automatically be selected and the
Authentication Service User Schema - LDAP window will open.