Avocent DSView Installer/User Manual page 222

202 DSView 3 Software Installer/User Guide
f. If you changed any settings, click Save.
6. To change cursor settings (see Cursor profile settings on page 198):
a. Click Cursor in the side navigation bar. The Cursor Settings window will open.
b. In the Local Cursor field, if you do not check the Inherit Default Settings checkbox,
enable the radio button for the desired cursor type. Check or uncheck the Allow users to
override this setting checkbox.
c. In the Single Cursor Mode - Session Startup field, indicate whether the Video Viewer will
start up in single cursor mode. In the Single Cursor Mode - Release Keystroke field, select
the keystroke that will release the Video Viewer single cursor mode. Enable or disable the
Allow users to override these settings checkbox.
d. If you changed any settings, click Save.
7. To change toolbar settings (see Toolbar profile settings on page 199):
a. Click Toolbar in the side navigation bar. The Toolbar Settings window will open.
b. If this is not the default profile, the Inherit Default Settings checkbox may be enabled or
disabled. When enabled, no other settings in this window may be changed.
c. In the Hide Delay field, select the number of seconds for the toolbar hide delay.
d. To add functions to be displayed in the toolbar, select one or more functions from the
Available Functions column, then click Add. The selected items will move to the Enabled
Functions column.
To add macros to be displayed in the toolbar, select one or more macros from the
Available Macros column, then click Add. The selected items will move to the Enabled
Macros column.
To remove functions or macros from display in the toolbar, select one or more items from
the Enabled Functions or Enabled Macros column, then click Remove. The selected items
will move to the Available Functions or Available Macros column.
e. Enable or disable the Allow users to override these settings checkbox.
f. If you changed any settings, click Save. The enabled functions will be displayed first in
the toolbar, followed by the enabled macros.
8. To change video settings (see Video profile settings on page 199):
a. Click Video in the side navigation bar. The Video Settings window will open.
b. In the Color Depth field, choose the desired value. Enable or disable the Allow users to
override these settings checkbox.
If users are allowed to override this setting, you may also enable or disable the Prohibit
users from selecting a higher value checkbox. When enabled, users may select a higher
color depth value than the current setting. When disabled, users may not select a higher
value, but they may select a lower value.
c. In the Video Scaling field, choose the desired value. Enable or disable the Allow users to
override these settings checkbox.