Avocent DSView Installer/User Manual page 165

2. Click Appliance Settings in the side navigation bar, click Ports and then Power device in the
side navigation bar. The Power Devices Attached to Appliance window will open. (For DSR
switches that have two SPC ports, one row will appear for each power device.)
3. Click on the name of a power device.
4. Click Input Feeds in the side navigation bar. The Power Device Input Feeds window will open.
Customizing the Power Device Input Feeds window
The following fields may be displayed in the Power Device Input Feeds window. Use the
Customize link to add or remove fields in the display. See Using the Customize link in windows on
page 12.
For information about Avocent SPC power device display fields, see the SPC Installer/User Guide.
For information about other power devices, see their product documentation.
• Input Feed Name
• Status - Unknown, on, off, cycling, pending off, pending on, pending cycle or no status
• Load
• Load Max - a trap will be sent if the Load value is greater than the Load Max value
• Load Min - a trap will be sent if the Load value is less than the Load Min value
To change power device input feed information:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the appliance name.
2. Click Appliance Settings in the side navigation bar, click Ports and then Power device in the
side navigation bar. The Power Devices Attached to Appliance window will open.
3. Click on the name of a power device.
4. Click Input Feeds in the side navigation bar. The Power Device Input Feeds window will open.
5. Click on an input feed name. The Power Device Input Feed Settings window will open.This
window will contain only those fields that are valid for the supported power device (Avocent
or Server Technologies).
Some fields are read-only (for example, unit name and status). For fields that can be modified,
enter or select new values.
6. Click Save and then click Close. The Power Device Sockets window will open.
7. Click Close. The Power Devices Attached to Appliance window will open.
8. Click Close. The Units View window will open.
Chapter 4: Managing Units 145