Avocent DSView Installer/User Manual page 84

64 DSView 3 Software Installer/User Guide
c. In the Group Container field, specify the name of the container to search for user groups.
This will limit the search scope to that container. The name may be entered in several
forms, optionally including a sub-domain. Valid forms are explained in step 5b above.
d. In the Username Type menu, select the type of username. Each choice in the menu
contains an example.
A Full Windows 2000 username is specified as username@domain.
A Partial Windows 2000 username is specified as username.
A Full Pre-Windows 2000 username is specified as domain\username.
A Partial Pre-Windows 2000 username is specified as username.
This option may only be configured for new authentication servers; it cannot be modified.
Existing authentication servers are set to the Partial Windows 2000 Username type
for compatibility.
e. Specify a Secure Socket Layer (SSL) encryption mode:
•
•
•
f. Click Use Kerberos for User Authentication to use the Kerberos protocol for
authentication requests, including the browsing. If enabled, you must use DES encryption
types for this account. If an account was created prior to Active Directory, the user's
password must be changed after this setting is changed. In addition, the Active Directory
server addresses must be resolvable to their host names via DNS.
When this is not checked, the LDAP protocol will be used.
g. Click Enable Chasing of Referrals to allow the Active Directory server to refer DSView 3
software clients to additional directory servers.
h. Click Use an Active Directory Global Catalog to have the AD service access the global
catalog for the specified domain name.
i. Click Next.
If you selected Use SSL in Certificate-based Trust Mode, go to step 6.
If you selected Do Not Use SSL or Use SSL in Trust All Mode, go to step 8.
Example 1 (with sub-domain and no container specified):
"mktg.sunrise.mycompany.com/"
Example 2 (with sub-domain):
"ou=myusers,ou=sun,dc=mktg,dc=sunrise,dc=mycompany,dc=com"
Click Do Not Use SSL to have authentication performed using unencrypted clear text
instead of SSL encryption. This method is the least secure.
Click Use SSL in Trust All Mode to use SSL encryption for data transmission. All
server certificates will be trusted and automatically accepted by the DSView 3 soft-
ware for transmitting data. This SSL method provides medium security.
This encryption mode is not recommended for wide area networks (WANs).
Click Use SSL in Certificate-based Trust Mode to use SSL encryption for data trans-
mission. The DSView 3 management software will approve the server and then the
certificate before transmitting data. This SSL method provides maximum security.