Avocent DSView Installer/User Manual page 164

144 DSView 3 Software Installer/User Guide
(You may also access the Power Management Wizard by clicking Appliance Settings, then
Ports, then Power device in the side navigation bar, and then clicking Manage.)
3. The Select Action window will open.
• To add a power device, enable the Add Power Devices radio button.
• To remove a power device, enable the Remove Power Devices radio button.
Click Next.
4. The Select Parameters window will open.
a. Specify the port where the power device will be added or removed.
•
•
b. If you are adding a power device, indicate the type (for example, SPC for an Avocent SPC
power device or SERVERTECH for a supported Server Technologies power device) in
the Power Device Type field.
c. Click Next.
5. A Completed Successful or Completed Unsuccessful window will open, indicating the results
of the addition or removal. Click Finish.
To change power device settings:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the appliance name.
2. Click Appliance Settings in the side navigation bar, click Ports and then Power device in the
side navigation bar. The Power Devices Attached to Appliance window will open. (For DSR
switches that have two SPC ports, one row will appear for each power device.)
3. Click on the name of a power device. The Power Device Settings window will open. This
window will contain only those fields that are valid for the supported power device (Avocent
or Server Technologies).
Some fields are read-only (for example, unit name and status). For fields that can be modified,
enter or select new values. (If you change the appliance name and the automatic name pull
feature is enabled, see Automatic name pull on page 105 for the effect.)
4. Click Save and then click Close. The Power Devices Attached to Appliances window
will open.
5. Click Close. The Units View window will open.
To display power device input feed information:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the appliance name.
For a DSR switch containing one SPC port, the Port field will indicate SPC and
cannot be changed. For a DSR switch containing more than one SPC port, the Port
field will contain entries for each (for example, SPC 1 and SPC 2).
For a CCM/CPS appliance, select the physical port number in the Port field.