Avocent DSView Installer/User Manual page 104

84 DSView 3 Software Installer/User Guide
By default, the replication task runs every 12 hours. You may change the schedule type, start
time, date and interval.
5. To force the spoke server to retrieve a snapshot of the hub database rather than synchronizing
changes, click Properties in the side navigation bar and then click the Perform a hub database
snapshot the next time this task executes checkbox. This setting will be reset to unchecked
after the operation completes.
6. If you made any changes, click Save and then Close.
You may also display the replication schedule from the hub server, but you cannot change it.
To initiate an immediate replication on a spoke server:
1. On the spoke server, click the System tab.
2. Click Tasks in the top navigation bar. The Tasks window will open.
3. Check the checkbox to the left of the Database Replication task and then click Run Now.
To display the replication schedule for a spoke server from the hub server:
1. On the hub server, click the System tab.
2. Click Tasks in the top navigation bar.
3. Select the Database Replication task for the spoke server you wish to view. The Task Schedule
- Database Replication window will open.