Dsview 3 Software Events; Table 10.2: Appliance Events - Avocent DSView Installer/User Manual

• Category - Category of an event log entry: Appliance, System, Authentication, Users, Units,
Tasks, Unit Status, Access Control, Sessions and Target Device.
• Detailed Description - Detailed event information, which may include the name of a target
device, session type (KVM, serial or virtual media), DSView 3 software server, user and so on.
For example, an MIB-II interface link up trap would contain Appliance change of state in the
Description column, while the Detailed Description column would contain Generic link up
interface 1.
• DSView Server - Name of the DSView 3 software server where the event was logged.
• Event ID - Unique event identifier. This is useful for filtering and sorting displays based on a
specific event type.
• Trap Enterprise - Enterprise object identifier for a received SNMP trap.
• Unit - Name of a managed appliance for an event.
• User - User associated with an event. For example, when a Unit Deleted event is detected, this
field shows the name of the user.

DSView 3 software events

Table 10.2 lists the appliance events that may occur within a DSView 3 software system.

Table 10.2: Appliance Events

Event ID
1:0
1:1
1:2
1:3
1:4
1:5
1:6
1:7
1:8
1:9
1:10
Description
An unrecognized event was received
Appliance cold start
Appliance warm start
Appliance session started
Appliance session stopped
Appliance session terminated
Appliance component added
Appliance component removed
Appliance component restarted
Appliance change of state
Appliance upgrade started
Chapter 10: Event Logs
Event ID Description
1:11 Appliance upgrade result
1:12 Appliance authentication failure
1:13 Appliance diagnostic information
1:14 Appliance user logged in
1:15 Appliance user logged out
1:16 Appliance alert from attached server
1:17 Appliance configuration changed
1:18 Appliance command issued
1:19 Appliance incorrect state detected
1:20 Appliance threshold exceeded
289