Examples; Denying A Specific Subnet - Patton electronics IPLink 3210 Series Getting Started Manual

IPLink 3210 Series Getting Started Guide

Examples

Denying a specific subnet
Figure 15 shows an example in which a server attached to network 172.16.1.0 shall not be accessible from outside
networks connected to IP interface lan of the IPLink device. To prevent access, an incoming filter rule named
Jamming is defined, which blocks any IP traffic from network 172.16.2.0 and has to be bound to IP interface lan.
Server
The commands that have to be entered are listed below. The commands access the IPLink device via a Telnet
session running on a host with IP address 172.16.2.13, which accesses the IPLink via IP interface lan.
172.16.2.1>enable
172.16.2.1#configure
172.16.2.1(cfg)#profile acl Jamming
172.16.2.1(pf-acl)[Jamming]#deny ip 172.16.2.0 0.0.0.255 172.16.1.0 0.0.0.255
172.16.2.1(pf-acl)[Jamming]#permit ip any any
172.16.2.1(pf-acl)[Jamming]#exit
172.16.2.1(cfg)#context ip router
172.16.2.1(cfg-ip)[router]#interface lan
172.16.2.1(if-ip)[lan]#use profile acl Jamming in
172.16.2.1(if-ip)[lan]#exit
172.16.2.1(cfg-ip)#copy running-config startup-config

Examples

172.16.1.0
secure
172.16.1.1/24
Figure 15. Deny a specific subnet on an interface
6 • Access control list configuration
172.16.2.0
lan
Node
Node
172.16.2.1/24
Host
172.16.2.13/24
70