Table of Contents
Advertisement
IPLink 3210 Series Getting Started Guide
Planning the installation
Before you start the actual installation, we strongly recommend that you gather all the information you will
need to install and setup the device. See
to carry out. Completing the pre-installation checks enables you to install and set up your VPN router within
an existing network infrastructure with confidence.
CAUTION
Note
Before installing the VPN Router device, the following tasks should be completed:
•
Create a network diagram (see section
•
Gather IP related information (see section
•
Install the hardware and software needed to configure the IPLink router. (See section
on page 29)
•
Verify power source reliability (see section
When you finish preparing for your VPN Router installation, go to section
page 30 to install the device.
Planning the installation
table 3
for an example of what pre-installment checks you might need
The mains outlet that is utilized to power the equipment must be
within 1 meter (3 feet) of the device and shall be easily accessible.
When setting up your VPN router you must consider cable length
limitations, and potential electromagnetic interference (EMI) as
defined by the applicable local and international regulations. Ensure
that your site is properly prepared before beginning installation.
"Network information"
"IP related information"
"Power source"
2 • Hardware installation
on page 29)
on page 29 for more information)
on page 29).
"Installing the VPN router"
"Software tools"
on
27
Advertisement
Table of Contents
