ipRocketLink™ Model 3101 Series ADSL2/2+ Router Quick Start Guide Important —This is a Class B device and is intended for use in a light industrial (commercial) or resi- dential environment. It is not intended for use in a heavy industrial environment. Part Number: 07M3101-QS, Rev.
Page 2
• Do not open the device when the power cord is connected. For sys- tems without a power switch and without an external power adapter, line voltages are present within the device when the power WARNING cord is connected. • For devices with an external power adapter, the power adapter shall be a listed Limited Power Source The mains outlet that is utilized to power the device shall be within 10 feet (3 meters) of the device, shall be easily accessible, and protected by a circuit breaker in compli-...
Electrostatic Discharge (ESD) can damage equipment and impair electrical circuitry. It occurs when electronic printed circuit cards are improperly handled and can result in complete or intermittent failures. Do the follow- CAUTION ing to prevent ESD: • Always follow ESD prevention procedures when removing and replac- ing cards.
L i n Connect to LAN or Ethernet port Figure 1. 2.2 Log in via web browser Launch a Web browser on your computer. Browse to “http://192.168.1.1” (the 3101’s default IP address).The login page displays. Enter a username and password. The default superuser username and password are both admin. The default operator/common username and password are both user.
3.0 Connect the ADSL port Obtain a single-twisted-pair cable with an RJ-11 plug connector at each end. Plug one end of the cable into the RJ-11socket labeled Line on the ipRocketLink Router. Plug the other end of the cable into the RJ-11 wall socket that provides your DSL service. When a DSL link is established, the front panel Line LED will turn on.
B.0 Compliance Information B.1 Compliance EMC: EN55022, Class A • EN55024 • Safety: IEC/EN60950-1, 2nd Edition • PSTN: IEC/EN60950-1, 2nd Edition • B.2 CE Declaration of Conformity Patton Electronics, Inc declares that this device is in compliance with the essential requirements and other rele- vant provisions of Directive 2004/108/EC relating to electromagnetic compatibility and Directive 2006/95/EC relating to electrical equipment designed for use within certain voltage limits.