Vpn Router Front Panel Leds And Console Port Locations - Patton electronics IPLink 3210 Series Getting Started Manual

IPLink 3210 Series Getting Started Guide
CAUTION
3. Verify that the AC power cord included with your VPN Router is compatible with local standards. If it is
not, refer to chapter 9,
compatible power cord.
4. Connect the male end of the power cord to an appropriate power outlet.
Figure 9. VPN Router front panel LEDs and Console port locations
5. Verify that the green Power LED is lit (see
Congratulations, you have finished installing the IPLink VPN Router! Now go to chapter 3,
with the IPLink" on page 34.
Installing the VPN router
The UI and EUI power supplies automatically adjust to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
"Contacting Patton for assistance"
0
e t
E n
Power
Run
Enet 0
Link
figure
on page 92 to find out how to replace it with a
e r
u t
R o
P N
k V
L i n
I P
o l e
n s
C o
1
e t
E n
Enet 0 Enet 1
Enet 0 Enet 1
100M 100M
Enet 0 Enet 1 Enet 1
Activity Link Activity
9).
2 • Hardware installation
IPLink VPN Router
Console Console
Console
port
"Getting started
33