Related Manuals for Patton electronics IM2RC/IA
Summary of Contents for Patton electronics IM2RC/IA
- Page 1 MODEL IM2RC/IA Ethernet Bridge Module Part# 07MIM2RC/IA-A SALES OFFICE Doc# 078521UA (301) 975-1000 Revised 06/24/99 TECHNICAL SUPPORT C E R T I F I E D (301) 975-1007 http://www.patton.com An ISO-9001 Certified Company...
-
Page 2: Radio And Tv Interference
However, this is no guarantee that interfer- ence will not occur in a particular installation. If the Model IM2RC/IA does cause interference to radio or television reception, which can be... -
Page 3: Typical Application
Patton Electronics rack card modem (i.e. Model 1092ARC or 1095RC). during installation or use of this product, please do not hesitate to con- The Model IM2RC/IA is designed to be used as one of a pair of units. tact us at: (301) 975-1007, http://www.patton.com; support@pat- Figure 1 (below) illustrates a typical Model IM2RC/IA installation. -
Page 4: Connecting The Interface Driver Board
Interface Driver Board Bit Rate: The DTE rate setting of your base unit corresponds to the throughput of your IM2RC/IA bridge module. Use higher speeds to allow maximum throughput to your extended LAN. Use lower speeds to limit the access of your extended LAN. - Page 5 50 pin card edge connectors. Use the following only 3.5” high, the Model 1001R14 is designed to occupy only 2U in a steps as a guideline for installing each Model IM2RC/IA and its func- tion card mate into the rack chassis:...
-
Page 6: Connecting To The 10Base-T Ethernet Port
Type 4 or 5 cable. 4.3.3 CONNECTING THE LINE INTERFACE 1 TD+ (data output from IM1/I) The Model IM2RC/IA is to be used with Patton function card access 2 TD- (data output from IM1/I) products (i.e. 1092ARC) There are two essential requirements for con-... -
Page 7: Led Status Monitors
In order to operate, the Model IM2RC/IA must be installed in the acceptable . Figure 6, below, rack unit. It also requires a 10Base-T connection. After power is... - Page 8 Status Blinks yellow from one to eleven times to indicate system PATTON ELECTRONICS MODEL IM2RC/IA status. Each pulse pattern is separated by a 2 second “off” SPECIFICATIONS period. Greater pulse patterns have higher priority (buffer sat uration has greater priority than an empty MAC table). Valid...
- Page 9 1000RCM70364DB ..Ethernet Daughter Board Pin # Signal 07MIM2RC/IA....IM2RC/IA User Manual TD + (data output from IM2RC/IA) TD - (data output from IM2RC/IA)