Installing The Dsl Cable; Connecting An Iplink 3210 Series Device To A Hub; Ethernet 10/100Base-T (Rj-45) Port Pin-Outs - Patton electronics IPLink 3210 Series Getting Started Manual

IPLink 3210 Series Getting Started Guide
figure 7). Ethernet devices (10Base-T or 100Base-T) are connected to the IPLink's Ethernet ports (see
for port pin-out listing) via a cable terminated with RJ-45 plugs.
Note
RJ-45, male
Tx+ 1
Tx- 2
Rx+ 3
Rx- 6

Installing the DSL cable

The IPLink 3210 comes with a G.SHDSL interface. Use a straight-through RJ-11 cable to connect the DSL
port.
Installing the VPN router
Table 5. Ethernet 10/100Base-T (RJ-45) port pin-outs
Pin
1
2
3
6
Pins not listed are not used.
Straight-through cable
Figure 7. Connecting an IPLink 3210 Series device to a hub
2 • Hardware installation
Signal
TX+
TX-
RX+
RX-
Hub
RJ-45, male
1 Rx+
2 Rx-
3 Tx+
6 Tx-
table 5
31