Installing An Interface Cable On The Iplink 2603'S T1/E1 Interface Port; Rear View Of The 2603/T Showing Location Of Ethernet And Wan Connectors; Rj-48C Pinout Diagram - Patton electronics IPLink 2603 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide

Installing an interface cable on the IPLink 2603's T1/E1 interface port

The IPLink Models 2603/K and 2603/T come with a selectable T1/E1 WAN interface (see
on the back of the IPLink, the T1 and E1 interfaces are presented on an RJ-48C connector with selectable line
impedances of 100-ohms for T1 and 120-ohms for E1 lines (see
BNC for alternate connection to unbalanced 75-ohm E1 lines (see
CAUTION
Power
Figure 4. Rear View of the 2603/T showing location of Ethernet and WAN connectors
Hardware installation
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
10/100
Crossover
MDI-X
Ethernet
Ethernet connector
(RJ-45)
1 0
/ 1 0
0
P o
w e
r
C r
o s
E t
h e
r n
e t
M D
RX RX
1 2 3 4 5 6 7 8
Figure 5. RJ-48C pinout diagram
figure 5). The 2603/K also comes with dual
figure 6
WAN
WAN connector
(RJ-48C)
s o
v e
r
I - X
W
A N
TX TX
3 • Initial Configuration
figure 4). Located
on page 30).
29