Table of Contents
Advertisement
Setup menus
USER menu
<TAPE PROTECT>
No.
400
401
402
403
The underline on the setting item denotes the initial setting.
<Note>
The cumulative standby time at the same tape position increases when transmitting
programs or otherwise using identical materials repeatedly.
Item
Setting
Superimposed
Superimposed
No.
display
display
STILL
0000
TIMER
0001
0002
0003
0004
0005
0006
0007
0008
SRC
0000
PROTECT
0001
0002
DRUM
0000
STDBY
0001
STOP
0000
PROTECT
0001
0002
– 85 –
0.5s
This selects the time to be taken until the unit goes into the tape
5s
protection mode when it is left standing in the stop or search still
10s
(JOG/VAR/SHTL) mode. (Unit: s = second, min = minute)
20s
<Note>
With DV/DVCAM tape used, the time is 10 sec. even when 2
30s
(10s) or over is selected.
40s
50s
1min
2min
STEP
This selects the operation during the tape protection mode
HALF
when the unit is left standing in the still status during the
T-REL
search mode (JOG/VAR/SHTL).
0: STEP FWD.
1: HALF LOADING.
2: TENSION RELEASING
<Notes>
• When the total time of leaving in STILL mode with STEP
FWD selected reaches 30 min. (1 min. in case of DV/
DVCAM tape), the mode is automatically shifted to standby
OFF (HALF-LOADING).
• If the unit has been left standing for a total of 2 hours after
"tension release" was selected and operation transferred to
the tension release mode, it is automatically set to the
standby OFF (HALF-LOADING) mode.
case of a DV or DVCAM tape, transfer to the tension release
mode is inhibited, and operation proceeds as if "STEP FWD"
has been selected.
OFF
This selects the drum operation in
ON
LOADING) mode.
0: The drum stops rotating.
1: The drum continues rotating.
This selects the operation in the tape protection mode when
STEP
HALF
the unit has been left standing in the STOP mode.
T-REL
0: STEP FWD
1: HALF LOADING
2: TENSION RELEASING
<Notes>
• When the total time of leaving in STOP mode with STEP
FWD selected reaches 30 min. (1 min. in case of DV/
DVCAM tape), the mode is automatically shifted to standby
OFF (HALF-LOADING).
• If the unit has been left standing for a total of 2 hours after
"tension release" was selected and operation transferred to
the tension release mode, it is automatically set to the
standby OFF (HALF-LOADING) mode.
case of a DV or DVCAM tape, transfer to the tension release
mode is inhibited, and operation proceeds as if "STEP FWD"
has been selected.
Description
However, in the
standby OFF (HALF-
However, in the
Advertisement
Table of Contents
