Edit Menu - Panasonic AJ-HD1500P Operating Instructions Manual

Setup menus
USER menu
<EDIT>
No.
300
301
302
303
304
305
306
307
308
309
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed Superimposed
No.
display display
IN/OUT 0000
DEL 0001
NEGA 0000
FLASH 0001
CONFI EDIT 0000
0001
AUD EDIT 0000
IN 0001
AUD EDIT 0000
OUT 0001
AUTO 0000
ENTRY 0001
CF ADJ 0000
SEL 0001 RECORD
AFTER 0000
CUE-UP 0001
0002
VAR FWD 0000
MAX 0001
0002
VAR REV 0000
MAX 0001
0002
– 82 –
This selects the operation to be performed when an edit point
MANU
has been set incorrectly (when the OUT point is before the IN
AUTO
point).
0: Editing is not executed unless the illegal edit point is
cleared or set again properly.
1: The edit points already input are automatically cleared.
This selects whether to show a negative display when the IN
OFF
point is greater than the OUT point.
ON
0: No negative display.
1: Negative display.
OFF This selects whether to conduct simultaneous playback while
ON editing is in progress.
0: No simultaneous playback
1: Simultaneous playback
<Note>
Simultaneous playback is valid when the TAPE/EE switch is
set to TAPE.
CUT This selects the way in which the digital audio edit IN points
FADE are to be joined.
0: Cut processing
1: V-fade processing
This selects the way in which the digital audio edit OUT points
CUT
are to be joined.
FADE
0: Cut processing
1: V-fade processing
DIS This selects whether the IN point is to be entered using the
ENA PREROLL button when it has not been entered.
0: IN point is not entered.
1: IN point is entered.
This selects the CF adjustment deck with deck-to-deck
PLAYER
editing.
0: The player's edit IN/OUT points are adjusted. (reference as
the RECORDER side)
1: The recorder's edit IN/OUT points are adjusted. (reference
as the PLAYER side)
This selects the mode after cue-up operation is complete.
STOP
0: STOP mode
STILL
1: SHTL STILL mode
STILL2
2: VAR STILL mode
+4.9 This sets the maximum VAR FWD speed.
+2 0: +4.9 speed
1: +2 speed (+1.85 speed for all formats except DVCPROHD-LP)
+1
2: +1 speed
<Notes>
• At any speed setting other than 0 (+4.9 ), the phase cannot
be synchronized from the editing controller.
• Depending on the tape format, the actual tape travel speed
will differ slightly from what the superimposed display shows.
This sets the maximum VAR REV speed.
–4.9
0: –4.9 speed
–2
1: –2 speed (–1.85 speed for all formats except DVCPROHD-LP)
–1
2: –1 speed
<Note>
Depending on the tape format, the actual tape travel speed
will differ slightly from what the superimposed display shows.
Description