Panasonic AJ-HD1500P Operating Instructions Manual page 70

Setup menus
SYSTEM menu
Video output signal adjustments
A control matrix of the adjustments is shown below.
05: ENCODER SEL
REMOTE
<Note>
When the external
LOCAL
encoder remote controller
(AJ-ER50, option) is
used, VIDEO PHASE
and SYS PHASE of the
BOTH
encoder remote controller
will not operate.
Ext. encoder remote:
Unit:
Ext. encoder remote/Unit:
PARALLEL REMOTE output connector
The statuses established by a combination of more than one pin among the PARA OUT submenu (No.02) items are
shown below. Pin status "1" denotes active low and "0" denotes open.
(1) Error statuses
Pin 21
(2) TC input statuses
Pin 35
TC SRC1
(3) Tape recording inhibit status
CAS IBH1
Settings
06: V LEVEL CTRL
HD
SD
BOTH
HD
SD
BOTH
HD
SD
BOTH
Ext. encoder remote adjustment only.
Setup menu adjustment only.
Simultaneous adjustment from external encoder remote and setup menu is possible
but the result of adjustment from external encoder remote will not be reflected in the
setup menu.
Pin 24 Pin 34
ERR0 ERR1 ERR2
0 0 0
0 0 1
0 1 0
0 1 1
Pin 36
TC SRC2
0 0 External SLTC
0 1 External LTC
1 0 External SVITC (for external VITC with SD input)
1 1 INT
Pin 37 Pin 38
CAS IBH2
0 0 Recording on cassette enabled
0 1 Accidental erasure of cassette recording inhibited
650: Y LVL (HD)
651: P LVL (HD)
B
652: P LVL (HD)
R
653: BK LVL (HD)
External encoder remote controller
Not adjustable
Ext. encoder remote controller
Unit
Ext. encoder remote controller/Unit
Unit
Ext. encoder remote controller/Unit
SERVO NOT LOCKED
SERVO LOCKED
HIGH ERROR (amber)
HIGH ERROR (red)
ETC input status
Tape recording inhibit status
– 70 –
Item adjusted
654: Y LVL (SD)
655: P LVL (SD)
B
656: P LVL (SD)
R
657: BK LVL (SD)
Not adjustable
External encoder remote controller
External encoder remote controller
Unit
Unit
Ext. encoder remote controller/Unit
Ext. encoder remote controller/Unit
Error status
(Priority level 1)
(Priority level 4)
(Priority level 3)
(Priority level 2)