Table of Contents
Advertisement
Playback
1
2
3
4
<Note>
•
Check that the SERVO lamp is lighted during playback. If it flashes or if it is off, the images
played back will be disturbed.
Special playback (playback phase adjustments)
If two VTRs are to be used to play the same program, the playback phase between the VTRs
can be adjusted by changing the playback speed of one of the VTRs.
1
2
Insert the cassette tape, and place the unit in the stop mode.
Press the PLAY button.
Regular playback is now commenced.
Adjust the audio playback level.
Pull out the audio level controls and turn them clockwise or counterclockwise to adjust
the levels. Normally, they are kept in the pushed-in state (unity value).
To end playback, press the STOP button.
The VTR now goes into the stop mode.
Press the TRIM button ("+" or "-" button) while holding down the PLAY button. Each
time it is pressed, the playback speed is accelerated or decelerated in increments of
the number of playback framing fields selected by the setup menu item No.109
(CAP.LOCK) setting.
The SERVO lamp remains off while the tape is being played at an accelerated or
decelerated speed.
Upon completion of the playback phase adjustment, release the PLAY button. The
VTRs now return to the standard playback speed, and the SERVO lamp lights up.
– 31 –
Advertisement
Table of Contents
