Table of Contents
Advertisement
Recording
1
2
3
4
5
6
7
<Note>
•
Check that the SERVO lamp is lighted during recording. If it flashes or if it is off, the images
played back will be disturbed.
Set the accidental erasure prevention tab on the cassette tape to the "recording"
position and insert the tape.
Press the STOP button to place the unit in the stop mode.
Set the TAPE/EE switch to EE.
EE images now appear on the TV monitor.
Check that the REC INHIBIT lamp is off.
When this lamp is lighted, select "0 (OFF)" as the setup menu item No.113 (REC INH)
setting.
Select the video and audio input signals and adjust their levels.
5-1
Selecting video/audio input signals
1
Connect the signals to be recorded.
2
Select the input signals on the setup menus No. 600 (VIDEO IN SEL) and
NO.700 (AUDIO IN SEL).
5-2
Adjusting the audio level
1
Adjust the levels of the audio input signals in the audio CH1, CH2, CH3, CH4,
CH5, CH6, CH7, CH8 and analog cue channels selected by the setup menu
item No.700 setting. Normally, keep the audio input/output level controls \
pushed in (unity value).
The audio signals will be recorded at the proper level.
2
To adjust the recording level, pull out the controls \ and adjust them. With the
CUE signal, adjust the control in such a way that –20 dB will not be exceeded.
<Note>
When "CH1-CH4 (CH5-CH8)" is lighted at the audio channel selector display Z, the
audio input/output level controls \ and level meter [ will operate for CH1-CH4 (CH5-
CH8).
Press the PLAY button while holding down the REC button. The REC and PLAY lamps
light, and recording commences.
To end the recording, press the STOP button.
Recording is ended, and the unit goes into the stop mode.
– 30 –
Advertisement
Table of Contents
