Panasonic AJ-HD1500P Operating Instructions Manual page 57

Variable memory function
Variable memory editing operation procedure
Variable memory editing operation can be performed according to the following procedure, setting the
unit connected as a recorder to variable memory mode.
1
2
3
4
5
6
7
8
9
<Notes>
• The content stored in the memory will be cleared in a mode other than the variable memory mode.
Also, the memory will be cleared with power switch 1 turned OFF.
• Phase synchronization is not performed during playback up to the variable memory edit IN point.
Therefore, depending on the VTR used as the player and its speed setting, no guarantees are made
for the accuracy of the IN point.
• When conducting variable memory editing in the speed range of +1.0 to +2.0 , use VTRs whose
speeds can be guaranteed for both the recorder and player.
Select the edit mode by pressing ASMBL button V or desired INSERT button W.
Select VTR to be operated by pressing RECORDER or PLAYER button E.
Register IN/OUT point by using SET button T and IN/OUT button T.
The OUT point of PLAYER cannot be registered.
After selecting VTR of PLAYER by pressing PLAYER button E, set the initial speed by
the search dial P while pressing SET button T.
Simultaneously pressing both SET button T and PREVIEW/REVIEW button S results
in automatic prerolling for both PLAYER and RECORDER, then the VTR of PLAYER is
operated at the set initial speed up to the IN point.
After passing the IN point, turn the search dial P to memorize the playback speed of VTR.
When the tape has passed the OUT point set by RECORDER, the memory of the
playback speed will terminate.
When AUTO EDIT button R is pressed, variable memory editing is executed. Once
editing has been executed, the memorized speed will be cleared. The initial speed will
not be cleared however.
The result of editing can be checked by pressing PREVIEW/REVIEW button S.
– 57 –