Panasonic AJ-HD1500P Operating Instructions Manual page 87

Setup menus
USER menu
<TIME CODE>
No.
509
510
511
512
513
514
515
516
The underline on the setting item denotes the initial setting.
1
* : This item does not function unless the AJ-UC1500 up-converter board, available as an optional
accessory, has been installed.
SBC (sub code data) area:
This area is separate from the video and audio data area on the helical track. The time codes, recording dates and times, and
other tape control information complying with SMPTE/EBU standards are stored here. As with the conventional LTC (linear time
code), the time code can be read even during rewinding or fast forwarding. It can also be read out when the tape has stopped.
VAUX (video auxiliary data) area:
This area is to be found in the video data area on the helical track. The additional information relating to the video data is stored
here.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
PHASE 0000
CORR 0001
TCG CF 0000
FLAG 0001
DF MODE 0000
0001
TC OUT 0000
REF 0001
VITC OUT 0000
0001
HD EMBD 0000
VITC 0001
HD EMBD 0000
LTC 0001
EXT TC 0000
1
SL (SD)* 0001
– 87 –
OFF This selects whether to control the phase correction of the
ON
LTC generated by the TCG.
0: Phase correction control is not performed.
1: Phase correction control is performed.
OFF
This selects whether the CF flag of the TCG is to ON.
ON
0: CF flag is OFF.
1: CF flag is ON.
DF This selects the DF/NDF mode for CTL and TCG.
NDF 0: Drop frame mode.
1: Non-drop frame mode.
<Note>
The drop frame mode takes effect only when LOCAL is
established or when ENA has been selected as the setup
menu item No.001 (LOCAL ENA) setting.
V OUT This is used to switch the phase of the time code, which is
TC IN
output from the TIME CODE OUT connector, for the external
LTC input when the TC INT/EXT switch is at the EXT position.
(In EE mode only)
0: Time code is synchronized with output video signal.
1: Time code is synchronized with external time code input.
This selects the output method of VITC to be superimposed
SBC
on output video signal.
VAUX
0: Time code recorded in SBC region is outputted in playback
mode.
1: Time code recorded in VAUX region is outputted in
playback mode.
<Note>
VITC information detected by HD serial input is automatically
recorded in VAUX region when the picture is recorded.
OFF This selects whether VITC information is superimposed on HD
ON serial output.
0: VITC information is not superimposed.
1: VITC information is superimposed.
This selects whether LTC information is superimposed on HD
OFF
ON serial output.
0: LTC information is not superimposed.
1: LTC information is superimposed.
LTC For selecting the time code to be used if SD SDI has been
VITC selected as the setup menu item No.600 (VIDEO IN SEL)
setting when an external time code is to be used.
0: The LTC of the TIME CODE IN connector is used.
1: The VITC information added to the serial signals supplied
to the SD SDI IN connector is used.
Description