Panasonic AJ-HD1500P Operating Instructions Manual page 68

Setup menus
SYSTEM menu
<SYSTEM>
No.
12
Submenu screen for 12 [SYS H (HD)] menu
00
01
14
15
Submenu screen for 15 [VO SYS H (SD)] menu
00
01
The underline on the setting item denotes the initial setting.
1
* : With the HD output (HD tape playback or up-conversion output)
2
* : With the SD output (SD tape playback or down-conversion output)
(continued)
Item Setting
Superimposed Superimposed
No.
display display
SYS H
(HD)*1
COARSE 0000
0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
FINE 0000
:
1100
:
2200
SYS SC 0000
:
2
(SD)*
0108
:
0216
VO SYS 0000
2
H (SD)*
COARSE 0000
0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
FINE 0000
:
0858
:
1716
– 68 –
<SUB> For adjusting the HD SD output system phase.
When the STOP button is pressed, the display transfers to the
submenu screen; press the STOP button again to return the
display from the submenu screen.
–5H For adjusting the HD SDI output system phase in 1H steps.
–: To advance the phase.
–4H
–3H +: To delay the phase.
–2H <Note>
–1H This setting remains unchanged even when the factory setting
0H operation is performed.
+1H
+2H
+3H
+4H
+5H
–1100 For adjusting the HD SDI output system phase in 13.5ns
:
steps.
0 –: To advance the phase.
:
+: To delay the phase.
1100 <Note>
If setting operation is performed, the setting value does not
return to factory (default) setting.
–108 For adjusting the system phase over a total variable range of
:
more than n180o.
0 –: To advance the phase.
:
+: To delay the phase.
<Note>
108
If setting operation is performed, the setting value does not
return to factory (default) setting.
<SUB> For adjusting the VIDEO OUT system phase.
When the STOP button is pressed, the display transfers to the
submenu screen; press the STOP button again to return the
display from the submenu screen.
For adjusting the VIDEO OUT system phase in 1H steps.
–5H
–4H –: To advance the phase.
–3H +: To delay the phase.
–2H <Note>
–1H If setting operation is performed, the setting value does not
return to factory (default) setting.
0H
+1H
+2H
+3H
+4H
+5H
–0858 For adjusting the VIDEO OUT system phase in 37ns steps.
:
–: To advance the phase.
+: To delay the phase.
0
:
<Note>
0858 If setting operation is performed, the setting value does not
return to factory (default) setting.
Description