Edit Menu - Panasonic AJ-HD150 Operating Instructions Manual

Setup menus
USER menu
<EDIT>
No.
300
301
302
305
306
307
308
309
310
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed Superimposed
No.
display display
IN/OUT 0000
DEL 0001
NEGA 0000
FLASH 0001
CONFI EDIT 0000
0001
AUTO 0000
ENTRY 0001
CF ADJ 0000
SEL 0001 RECORD
AFTER 0000
CUE-UP 0001
VAR FWD 0000
MAX 0001
0002
VAR REV 0000
MAX 0001
0002
JOG FWD 0000
MAX 0001
0002
– 61 –
This selects the operation to be performed when an edit point
MANU
has been set incorrectly (when the OUT point is before the IN
AUTO
point).
0: Editing is not executed unless the illegal edit point is
cleared or set again properly.
1: The edit points already input are automatically cleared.
This selects whether to show a negative display when the IN
OFF
point is greater than the OUT point.
ON
0: No negative display.
1: Negative display.
OFF This selects whether to conduct simultaneous playback while
ON editing is in progress.
0: No simultaneous playback
1: Simultaneous playback
<Note>
Simultaneous playback is valid when the TAPE/EE switch is
set to TAPE.
DIS This selects whether the IN point is to be entered using the
ENA PREROLL button when it has not been entered.
0: IN point is not entered.
1: IN point is entered.
This selects the CF adjustment deck with deck-to-deck
PLAYER
editing.
0: The player's edit IN/OUT points are adjusted. (reference as
the RECORDER side)
1: The recorder's edit IN/OUT points are adjusted. (reference
as the PLAYER side)
This selects the mode after cue-up operation is complete.
STOP
0: STOP mode
STILL
1: SHTL STILL mode
+4.1 This sets the maximum VAR FWD speed.
+1.85 0: +4.1 speed
+1 1: +1.85 speed
2: +1 speed
<Note>
At any speed setting other than 0 (+4.1 ), the phase cannot
be synchronized from the editing controller.
This sets the maximum VAR REV speed.
–4.1
–1.85 0: –4.1 speed
–1 1: –1.85 speed
2: –1 speed
This sets the maximum JOG FWD speed.
+4.1
0: +4.1 speed
+1.85
1: +1.85 speed
+1
2: +1 speed
<Notes>
• The maximum speed is set to +1 when the dial on the front
panel is operated.
• At any speed setting other than 0 (+4.1 ), the phase cannot
be synchronized from an editing controller which synchro-
nizes the phase using the JOG command.
Description