Remote Connection (Telephone Modem) - Visonic Remote Programmer Software User Manual

7.1.2 Remote Connection (Telephone Modem)

This is applicable when the Remote Programmer is off-site and the
PowerMax/PowerMaster control panel on-site is connected to Remote Programmer
by a telephone modem.
1. From the Communications mode drop-down list, select one of the
following communication options:
Modem Type
PSTN direct
PSTN callback
GSM analog
direct
GSM digital direct
GSM analog callback
GSM DTMF callback
GSM digital callback
GSM communication enables the user to initiate both analog and digital
communication, as follows:
DE5450S Remote Programmer Guide Rev. 8
Figure 7-18: Progress Bar
Description
Dials to the control panel by the PSTN line at a baud rate of 300.
Dials to the control panel by the PSTN line at a baud rate of 300. The
control panel calls back.
Dials the GSM unit of the control panel by analog communication at a
baud rate of 300.
Dials the GSM unit of the control panel by digital communication at a
baud rate of 9600.
Dials the GSM unit of the control panel by analog communication at a
baud rate of 300. The control panel calls back at a baud rate of 9600.
This form of communication is used when transmission quality is poor.
DTMF signals instruct the panel to call back by digital communication
at a baud rate of 9600, using a Sony Ericsson Modem GM29
(mandatory).
Dials the GSM unit of the control panel at a baud rate of 9600. The
control panel calls back at a baud rate of 9600.
Chapter 7: Connecting to the Control Panel
47