Online Operations - Visonic Remote Programmer Software User Manual

Chapter 7: Connecting to the Control Panel

7.3 Online Operations

While connected to the PowerMax/PowerMaster control panel, you can perform the
following operations:

Check if the detectors in the various zones are enrolled and communicating
with the control panel.

Transfer information between the Remote Programmer and the control
panel by uploading or downloading either all site parameters or a specific
table.

Update the system date and time.
To check if a zone (detector) is enrolled and communicating with the
control panel
1. In the List of Tables panel, go to Installer Settings>Definition>Zone
and select the relevant detector type.
2. Click on the relevant zone number. A table representing the
selecting zone opens.
3. Check if the detector's LED blinks. If the LED blinks, communication
between the detector and the control panel is working normally.
4. To end the test and close the table, click OK or Cancel.
54 DE5450S Remote Programmer Guide Rev. 8