Visonic Remote Programmer Software User Manual page 48

Note: The Channel Lst. Msg. column displays the last channel on which data was
transmitted between the zone's installed device and the control panel. When the
transmissions between the control panel and devices change channels, the
channel indication is displayed in various colors, such as the purple and yellow
indications in the above figure.
Condition
BYPASS
ALARM
TROUBLE
OPEN
TAMPER ALARM
TAMPER OPEN
LOW BATTERY
AC FAILURE
INACTIVE
MODE
1-WAY ONLY
PRE-ENROLLED
DE5450S Remote Programmer Guide Rev. 8
Description of Yes state
Bypassing of zone is enabled.
Alarm is occurring in zone.
Trouble detected in zone.
Zone is open. For example, a room door was
opened.
Device tamper is occurring while system is an
Armed state.
Device tamper is occurring while system is either
in Armed or Disarmed state.
Battery needs replacement or is not connected.
Electrical power is not supplied.
Device is not communicating with control panel.
SET – System is armed.
UNSET – System is disarmed.
PERIODIC TEST – Periodic test (walk test) in
process.
DIAGNOSTIC TEST – Diagnostic test in
process.
Communication between device and control
panel occurring in one direction only.
Enrollment of the device is not complete –
device needs to be associated with the control
panel.
Chapter 6: Data Details Tables
41