User Settings - Visonic Remote Programmer Software User Manual

Chapter 6: Data Details Tables
Secondary Phone No.  : When the primary telephone number is engaged, the
Remote Programmer dials this telephone number.
Secondary Communication Mode  : The mode used to call a secondary telephone
number.
Note: If there is no entry for the secondary telephone number, the Remote
Programmer will dial the primary telephone only.
Note: If the dialed telephone number is engaged or there is no answer, the
Remote Programmer will toggle between the primary telephone number and the
secondary telephone number.
Time Zone: Select from the list the relevant time zone.
Download Code: A 4-digit password, including letters A-F, used to enable
downloading data to the control panel. In the PowerG version, you can set
separate passwords for the Master Installer and the Installer.
Installer Code: A 4-digit password used to manage the control panel via the built-in
keypad. In the PowerG version, you can set separate passwords for the Master
Installer and the Installer.

6.2 User Settings

User Settings enables you to define panel settings, applicable to each individual
site.
Set User Tel No.: Type the telephone number where the user can be reached
while away from the site. The control panel will call this number to report the event
types defined by the installer in the Communications Definitions screen. Do not use
any parentheses or dashes when typing the number.
Note: In PowerMax+ and PowerG, it is possible to enter 4 private telephone
numbers in this table.
Set Voice Option: You can either enable or disable the voice prompts and
messages.
Note: You can only hear voice prompts from the control panel, not from the
Remote Programmer.
30 DE5450S Remote Programmer Guide Rev. 8