Resiliency Link Configurations Via Switch Ports; Figure 31. Resiliency Link Connecting To Switch Ports Over The Resiliencylink Vlan; Figure 32. Resiliency Link Connecting To Switch Ports Over The Resiliencylink Vlan Using A Network Hub - Allied Telesis 48Ts/X Installation Manual

Resiliency Link
Configurations
via Switch Ports
Two resiliency-link configurations that connect to switch ports are shown
below. Figure 31 shows the resiliency link connecting in a ring topology,
whilst Figure 32 shows the resiliency link connecting to its switch ports via
a network hub. In both configurations, the resiliency link connections are
made using the ResiliencyLink VLAN and attaching the switch ports to the
VLAN.
For more information about the stack resiliency link refer to the Stacking
Introduction and Stacking Commands chapters in the AlliedWare Plus
Operating System Software Reference from www.alliedtelesis.com.
Stack Resiliency Link -
x610-24Ts
x610-24Ts
Figure 31. Resiliency link Connecting to Switch Ports Over the
x610-24Ts
x610-24Ts
Figure 32. Resiliency link Connecting to sWitch Ports Over the
ResiliencyLink VLAN Using a Network Hub
x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
Connecting to Switch Ports
Stacking Links
ResiliencyLink VLAN
ResiliencyLink VLAN
Network Hub
Resiliency Links
to Switch Ports
Stacking Links
x610-24Ts
x610-24Ts
x610-24Ts
x610-24Ts
61