Video Off Method; Video Off In Suspend; Suspend Type; Modem Use Irq - Albatron PM845GV1 User Manual

Video Off Method

This option determines the manner in which the monitor is goes blank. Options:
1. Blank Screen (default): This option only writes blanks to the video buffer.
2. V/H SYNC+Blank: This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
3. DPMS Support: Initial display power management signaling.

Video Off In Suspend

Set if the monitor will be on when the system suspend. Options: No (default), yes.

Suspend Type

The item allows you to select the suspend type under ACPI operating system.
Options: Stop grant (default), PWROn Suspend.

Modem Use IRQ

This determines the IRQ, which can be applied in MODEM use.
Options: NA, 3 (default), 4, 5, 7, 9, 10, 11.

Suspend Mode

This allows you to select the suspend type under the ACPI operating system. Options:
Disabled (default), 1 Min, 2 Min, 4 Min, 6 Min, 8 Min, 10 Min, 20 Min, 30 Min, 40 Min,
1 Hour.

HDD Power Down

When "Enabled", the hard disk drive will power down after a certain configurable
period of system inactivity. All other devices remain active.
Options: Disabled (default), 1Min ~ 15Min.
Software-Off by PWR-BTTN
When you select Enabled, pressing the power button for more than 4 seconds forces the
system to enter the Soft-Off state when the system has "hung."
Options: Instant Off (default), Delay 4 Sec.
Wake Up Control
If you highlight the "Wake Up Control" label and then press the enter key, it will take
you a submenu with the following options:
PCI PME Wake Up
When "Enabled", any events occur to PCI card or Onboard LAN Device will wake up
the system by PME message. Options: Disabled (default), Enabled.
PM845GV1/ PM845GE1/ PM845GL/1 PM845GL1-533
33