Table of Contents
Advertisement
Suspend Mode = 1hour
HDD Power Down = 15 minutes
2. Max. Saving
Maximum power management (only available for sl CPUs)
Suspend Mode = 1 minute
HDD Power Down = 1 minute
3. User Defined (default)
Allow to set each mode individually
When this option is enabled, each of the ranges are from 1 minute to 1 hour except for HDD Power
Down, which ranges from 1 minute to 15 minute and includes a "disable" option.
Note: If you select Min. or Max. Power Saving modes, the "HDD Power Down" value and the "Suspend
Mode" value are both fixed.
HDD Power Down
When enabled, the hard disk drive will power down after a certain configurable period of system
inactivity. All other devices remain active.
Options: Disabled (default)、1 Min、2 Min、3 Min、4 Min、5 Min、6 Min、7 Min、8 Min、9 Min、10 Min、
11 Min、12 Min、13 Min、14 Min、15Min
Suspend Mode
This item allows you to select the suspend time under the ACPI operating system.
Options: Disabled(default)、1Min、2Min、4Min、6Min、8Min、10Min、20Min、30Min、40Min、1Hour
Video Off Option
This field determines when to activate the video off feature for monitor power management.
Options: Always On、Suspend → Off (default)
Video Off Method
This option determines the manner in which the monitor goes blank.
Options:
Blank Screen (default)
V/H SYNC+Blank
DPMS Support
Modem Use IRQ
This determines the modem's IRQ. Options: NA、3 (default)、4、5、7、9、10、11
Soft-off by PWRBTN
In situations where the system enters a "hung" state, you can configure the BIOS so that you are
required to pre the power button for more than 4 seconds before the system enters the Soft-Off state.
Options: Delay 4 Sec、Instant-Off (default).
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
Initial display power management signaling.
30
Hide quick links:
Advertisement
Table of Contents
