To Save, Recall, And Clear Traces - HP 54645A User's And Service Manual

Saving and Recalling the Configuration

To save, recall, and clear traces

To save, recall, and clear traces
To save traces, two trace memories are available. The following exercise
shows you how to store and recall waveforms from pixel memories.
Connect a signal to the oscilloscope and obtain a stable display.
1
Press .
2
Trace
A softkey menu appears with trace memory selections.
Trace selects trace memories Mem1 or Mem2 (Trace 1 - Trace 100 if
the oscilloscope has a Measurement/Storage module installed).
Trace Mem<N> turns on or off the selected trace memory.
<N> is the trace memory number.
Save to Mem<N> saves the displayed waveform to the selected trace
memory. (Front-panel setups are saved to separate memory locations.)
Clear Mem<N> erases the selected trace memory.
Recall Mem<N> Setup recalls the front-panel setup that was saved
with the waveform.
If a Measurement/Storage module is attached to the oscilloscope,
100 non-volatile trace memories are available.
Editing Trace Labels when Measurement/Storage Module is Attached
If a Measurement/Storage module is attached to the oscilloscope, an Edit Label
softkey appears and allows you to change the trace memory labels.
4-46