Front-Panel Overview
To use digital channels to view a signal
To use digital channels to view a signal
To configure the instrument quickly, press
.
Autoscale
To undo the effects of autoscale, press
, then press
Undo
Setup
.
Autoscale
To set the instrument to the factory-default measurement
configuration, press
, then press
Default Setup
.
Setup
Example
Install grabbers on channels D0 and D1. Connect the probes for digital
channels D0 and D1 to the calibrator output on the front panel of the
instrument. Be sure to connect the ground lead. Set the instrument to
, then Default
the factory default configuration by pressing
Setup
Setup. Then press
. You should see a display similar to the
Autoscale
following.
Figure 2-4
HP 54645D Sample Autoscale Measurement
2-18