To save or recall traces
The oscilloscope has two pixel memories for storing waveforms. The
following exercise guides you through how to store and recall waveforms
from pixel memories.
Connect a signal to the oscilloscope and obtain a stable display.
1
Press
.
2
Trace
A softkey menu appears with five softkey selections. Four of the softkeys are
trace memory functions.
Trace Selects memory 1 or memory 2.
Trace Mem Turns on or off the selected memory.
Save to Saves the waveform to the selected memory. The front-panel setup
is saved to a separate memory location.
Clear Erases the selected memory.
Recall Setup Recalls the front-panel setup that was saved with the
waveform.
Toggle the
Trace softkey to select memory 1 or memory 2.
3
Press the
Save to softkey.
4
The current display is copied to the selected memory.
Turn on the
Trace Mem softkey to view the stored waveform.
5
The trace is copied from the selected trace memory and is displayed in half
bright video.
Operating Your Oscilloscope
To save or recall traces
2–33