Vehicle Code Programming; 10.0 - Self-Learning Of Turn Indicators Flashes - Gemini 933 Series Installation And Use Manual

9.0 - VEHICLE CODE PROGRAMMING

I f the system is to be managed via CAN-BUS line, it must be configured according to the vehicle on
which it is to be installed.
To help you understand the coding procedure, here below is an example illustrating the configuration
procedure.
In this case the code used is 1-0-3 which hypothetically corresponds to a "FIAT XXXXX
A separate leaflet, included in the alarm packaging, lists all the available vehicles
(codes are updated at packaging time).
!
Up-to-date information on supported vehicle models can be found at: www.gemini-
The system has an indicator LED that signals any wrong vehicle code inserted.
The code must be range between 100 and 235 otherwise the LED on the unit blinks
repeatedly and the procedure is interrupted.
!
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times.
In this case there are no optical warnings, the procedure is simply be interrupted.
In either case, repeat the whole procedure.
Connect the connectors of the wiring harness to the connector of the system.
Press and hold the button shown below until the LED lights up
Release the button, the LED switches off.
After a 3/4 seconds pause, the LED starts the first sequence of flashes.
Press the button at the first flash which corresponds to number
After a 4 seconds, the LED starts the second sequence of flashes.
Press the button at the tenth flash which corresponds to number
After another 4 seconds, the LED starts the third sequence of flashes.
Push the button at third LED flashing, corresponding to value "3".
PAGE 10 - INSTALLER MANUAL
alarm.com (privat e area).
3-4 seconds
FIRST
FLASH
TENTH
FLASH
THIRD
FLASH
When the last digit is entered, the alarm system "repeats" the entered code.
".
Press the vehicle remote control lock/unlock buttons to make sure the alarm system works
Eventually disconnect the 8-way connector and reconnect it after few seconds
In order to arm/disarm through the turn indicators, the system must learn the vehicle locking (arming)
and unlocking (disarming) flashes.
Connect the WHITE-ORANGE wire to the turn indicators and proceed as follows
.
!
Disconnect the 8-way wiring connector from the 8-way system connector.
!
Turn ignition key "ON".
!
Connect the 8-way wiring connector to the 8-way system connector; the LED turns on steady.
!
T urn ignition key
!
C lose all doors and press the lock button on the original remote control.
!
When the turn indicators stop flashing, a high-pitched acoustic signal confirms the learning of the
arming flashes.
!
Press the unlock button on the original remote control.
!
When the turn indicators stop flashing, 2 high-pitched audio signals confirm the learning of the
disarming flashes.
!
This completes the procedure
"1".
!
Press
"0".
Press
Press
ONE FLASH AND A
SHORT PAUSE
TEN FLASHES AND
A SHORT PAUSE
THREE FLASHES
properly.

10.0 - SELF-LEARNING OF TURN INDICATORS FLASHES

"OFF".
.
To cancel the programming of the turn indicators reset the system (see
chapter 16.0).
:
INSTALLER MANUAL - PAGE 11