Table of Contents
Advertisement
8.0 - VEHICLE CODE PROGRAMMING
If the system is to be managed via CAN BUS, it must be configured with the code set up for the vehicle on
which it is to be installed.
Here below is an example illustrating the configuration procedure where the code to be entered is "1-0-3".
A separate leaflet, included in the alarm packaging, lists available vehicles (codes are
updated at packaging time).
!
Up-to-date information on supported vehicle models is available in the restricted area of
our website: www.gemini-alarm.com.
The system has an indicator LED that signals any wrong vehicle code inserted.
The code must range between 100 and 239 otherwise the LED on the unit blinks
repeatedly and the procedure is interrupted.
!
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times.
In this case there are no optical warnings, the procedure is simply interrupted.
In either case, repeat the entire procedure.
Connect the harness connectors to the alarm.
Press and hold the button shown below until the LED lights up.
Release the button, the LED switches off.
After 3-4 seconds, the LED starts flashing.
Press the button at the 1st flash which corresponds to the code 1st digit "1".
After 4 seconds, the LED starts flashing again.
Press the button at the10th flash which corresponds to the code 2nd digit "0".
After another 4 seconds, the LED flashes one last time.
Press the button at the 3rd flash which corresponds to the code 3rd digit "3".
PAGE 10 - INSTALLER MANUAL
3-4 seconds
1st
FLASH
10th
FLASH
3rd
FLASH
When the last digit is entered, the alarm system "repeats" the entered code "1-0-3".
Press the vehicle remote control lock/unlock buttons to make sure the alarm system works
If needed, disconnect the 8-pin connector and reconnect it after few seconds.
In order to arm/disarm via the turn indicators, the system must learn the vehicle lock (arm) and unlock
(disarm) flashes.
Connect the WHITE-ORANGE wire to the turn indicators and proceed as follows:
• Disconnect the 8-pin harness connector from the unit.
• Turn ignition key ON.
• Re-connect the 8-pin harness connector to the unit; the LED turns ON steady.
At this point you have 60 sec. to turn ignition key OFF and carry out the learning
!
procedure otherwise it will timeout with a Bop.
• Turn ignition key OFF, the LED will remain steady ON.
• Close all doors and press the lock button on the original remote control.
• When the turn indicators stop flashing, a Beep confirms the arming flashes have been learnt.
• Press the unlock button on the original remote control.
• When the turn indicators stop flashing, 2 Beeps confirm the disarming flashes have been learnt.
• The system will automatically exit the procedure.
Press
If the ignition key is turned OFF before the 60-sec. timeout, the 60-sec.countdown restarts to allow
learning the turn indicators. It will timeout with a Bop.
If, after the ignition key is turned OFF, it is turned back ON, the procedure is interrupted with a Bop.
!
To cancel the programming of the turn indicators reset the system (par. 13.0).
Press
Press
1 FLASH AND A
SHORT PAUSE
10 FLASHES AND A
SHORT PAUSE
3 FLASHES
properly.
9.0 - LEARNING TURN INDICATORS FLASHES
INSTALLER MANUAL - PAGE 11
Advertisement
Table of Contents
