Programming Example; Tilt Sensor Adjustment - Gemini 953N User's And Installer's Manual

25.0 - PROGRAMMING EXAMPLE

Here below is a step-by-step example showing how to program the system
with the acoustic signals, the panic alarm and the pre-alarm features enabled.
.
Keep in mind that, at every button press, the system automatically scrolls to the
next feature.
!
With the system disarmed, lift the seat/topcase (if protected by a contact
switch) otherwise ground the BROWN/GREEN wire.
!
Turn ignition key in ON; the LED will light up for approx. 1 sec.
!
While the LED is ON, simultaneously press both remote control buttons; 2
Beeps will confirm the system is in programming mode. The LED will also
light up steady.
!
Press remote control button 1; a Beep will confirm
been enabled.
!
Press remote control button 1 ; a Beep will confirm that the
been enabled.
!
Press button 2; a Bop will confirm that the
Press button 2; a Bop will confirm that
enabled.
!
Press button 2; a Bop will confirm that the
enabled.
!
Press button 1; a Beep will confirm that the
enabled.
!
Press button 2; a Bop will confirm that
!
When the last feature has been configured, the system automatically exits
the programming procedure; 2 Bops and 1 Beep will confirm the end of the
procedure. The status LED will power OFF.
!
Turn ignition key OFF, close the seat/topcase or remove the BROWN-
GREEN wire from ground.
CAUTION
You can exit the programming procedure at any time by turning ignition
key OFF.
Programmed features will automatically be saved while the others will
remain unvaried.
PAGE 27
acoustic signals have
panic alarm has
tilt sensor has been disabled.
passive arming has not been
anti-hijack feature has not been
pre-alarm feature has been
self-rearming has not been enabled.

26.0 - TILT SENSOR ADJUSTMENT

The alarm system has a built-in triaxial tilt/shock sensor with 4 levels of
sensitivity adjustment. T e shock sensor is factory preset to be at minimum h
sensitivity.
To change the sensitivity level proceed as follows:
!
Disarm the alarm system via remote control.
!
Lift the seat/topcase (if protected by a contact switch) otherwise ground the
BROWN/GREEN wire.
!
Turn ignition key ON; the status LED will turn ON for approx. 1 sec
! While the LED is ON, press remote control button 2 and press it again within 2 sec.
CAUTION
The procedure will be voided if more than 2 seconds go by between the
first button press and the second.
!
Two LED flashes and two Beeps will confirm the system is in adjustment
mode.
!
Sensor is at the lowest sensitivity level.
!
Press remote control button 2 to increase sensitivity by one (press 3 times
to set at maximum level); a LED flash and a Beep will confirm each change
of setting.
!
When the sensor is adjusted, turn ignition key OFF.
!
If adjusted at the highest level (3 button presses), the system automatically
exits the procedure.
!
In both cases, a LED flash and Beep will confirm the end of the procedure.
!
Turn ignition key OFF. Close the topcase/seat or remove the
BROWN/GREEN wire from ground .
CAUTION
Every time you enter the programming procedure, sensitivity is restored to
the factory default setting.
.
PAGE 28