Programming The Alarm System - Gemini 7590TK15 Installation And Use Manual

7.0 - PROGRAMMING THE ALARM SYSTEM

The alarm system has been factory configured but settings can be modified at
any time.
During programming, proceed as follows:
- To enable a function, press textured button '1' => LED will flash once
- To disable a function, press smooth button '2' => LED will flash twice.
To modify settings proceed as follows:
With the alarm disarmed, open the driver door and leave it open.
Turn ignition key "ON".
The status LED will turn ON for 0,5 seconds; while the LED is ON,,
simultaneously press both buttons on the remote control.
The turn indicators and the LED will flash twice to confirm the alarm is in
configuration mode.
To enable and/or disable the functions, proceed as indicated in the table
below. Keep in mind that each time a button is pressed, the system will go to
the next function.
FUNCTION
Continuous (siren) or
intermittent (horn)
CDL 0.5 or 6 sec.
25" comfort closure
Double pulse unlock
Current absorption sensor
Anti-distraction rearming and
auto-lock
Panic/boot release
f I ignition key if turned OFF" during configuration, the system will
NB:
procedure; the remaining
The end of the programming procedure is always confirmed by 2 flashes of
the turn indicators and the LED.
Turn ignition key "OFF" and close door.
Self-arming of engine immobilizer is factory enabled and
cannot be modified in the version for the UK market.
PAGE 10
DEFAULT setting
Continuous
0.5"
Disabled
Disabled
Disabled
Disabled
Panic function
"
functions will remain unchanged.
BUTTON 1
BUTTON 2
Intermittent
Continuous
(horn)
6"
Enable
Enable
Enable
Enable
Panic
(siren)
0.5"
Disable
Disable
Disable
Disable
Boot
e t i x h t e