Intergraph WebScale User Manual page 67

WebScale™
Event ID Event Message
7 WebScale : internal error. Please contact technical support.
8 WebScale : error registering driver with NDIS.
9 WebScale : driver does not support media type that was requested by
TCP/IP.
10 WebScale : driver could not allocate required memory pool.
11 WebScale : driver could not open device '\Device\AdapterN'.
12 WebScale : driver could not announce virtual NIC 'WebScaleN' to TCP/IP.
14 WebScale : cluster network address 'XX-XX-XX-XX-XX-XX' is invalid. Please
check WebScale Setup page and make sure that it consists of six
hexadecimal byte values separated by dashes.
16 WebScale : cluster IP address 'XXX.XXX.XXX.XXX' is invalid. Please check
WebScale Setup page and make sure that it consists of four decimal byte
values separated by dots.
17 WebScale : duplicate host priority 'N' was discovered on the network. Please
check WebScale Setup dialog on all hosts that belong to the cluster and
make sure that they all contain unique host priorities between 1 and the
maximum number of hosts.
21 WebScale : host 'N' does not have the same number or type of port rules as
this host. Please check WebScale Setup dialog on all machines that belong
to the cluster and make sure that they all contain the same number and the
same type of port rules.
31 WebScale : cluster network mask 'XXX.XXX.XXX.XXX' is invalid. Please
check WebScale Setup page and make sure that it consists of four decimal
byte values separated by dots.
34 WebScale : error querying parameters from the registry key
'RegistryParameter'. Please run WebScale Setup dialog to fix the problem
and run 'webscale reload' followed by 'webscale start'.
35 WebScale : cluster mode cannot be enabled due to parameter errors. All
traffic will be passed to TCP/IP. Restart cluster operations after fixing the
problem by running 'webscale reload' followed by 'webscale start'.
63
User's Guide