Intergraph WebScale User Manual page 23

WebScale™
Setup: Configuring WebScale's Parameters
WebScale must be configured on each host computer within the cluster using the
WebScale Setup dialog. This dialog appears automatically during the installation
process. After installation, it can be invoked from the Network setup dialog from
Control Panel folder as follows:
æ
In the Control Panel folder, double-click on the Network icon.
æ
Click on the Adapters tab to see the list of installed network adapters.
æ
Select WebScale Virtual NIC in the list of network adapters.
æ
Click on the Properties button.
The WebScale Setup dialog can also be started by running the command
webscale setup
from the command-line prompt. This method is more restrictive and will not allow you
to change all of WebScale's parameters.
The WebScale Setup dialog appears as follows:
19
User's Guide