Intergraph WebScale User Manual page 21

WebScale™
following Select OEM Option dialog, which lets you select WebScale for installation. If
you do not see this dialog, you should re-check that you have entered the correct path to
the WebScale installation files during the previous step, that the diskette you have
placed in your floppy drive contains WebScale installation files, and that the files have
not been corrupted.
æ
Click on the OK button.
Some files will be copied to your hard drive, and you will be presented with a screen
containing the license agreement. Make sure that you read and understand the
agreement; if you have any questions, please contact Intergraph Computer Systems.
æ
Click on the Agree button to accept the license agreement.
By doing so, you will be bound by this agreement. If you choose not to accept the
agreement, press the Disagree button and the installation will terminate. You will need
to manually remove the WebScale Virtual NIC adapter that was just installed. To do
this, highlight the WebScale Virtual NIC adapter shown in list of adapters in the
Network dialog and click on the Remove button. For more details on removing
WebScale, please refer to the Disabling and Removing WebScale section.
After you click on the Agree button for the WebScale license agreement, you will be
presented with the WebScale Setup dialog which lets you configure your system for
cluster operations.
æ
Configure your WebScale installation for cluster operations. Please refer now to
the Setup: Configuring WebScale's Parameters section for step-by-step
instructions on configuring WebScale.
æ
Click on the OK or Cancel button.
After you exit the WebScale Setup dialog, you should see WebScale Virtual NIC listed
17
User's Guide