Advertisement
Quick Links
Advertisement
Related Manuals for Intergraph InterServe Firewall
Summary of Contents for Intergraph InterServe Firewall
- Page 1 InterServe Firewall Quick-Start Guide January 1998 DSA077920...
- Page 2 Computer Systems or its affiliated companies. All warranties given by Intergraph Computer Systems about equipment or software are set forth in your purchase contract, and nothing stated in, or implied by, this document or its contents shall be considered or deemed a modification or amendment of such warranties.
-
Page 3: Table Of Contents
Contents Introduction ............................. 1 Getting Started ..........................2 Connecting to the Internet ......................... 2 Configuring Windows NT Server ...................... 3 Installing and Configuring Eagle NT....................4 Troubleshooting the Configuration ....................5 Frequently Asked Questions ......................5 Troubleshooting Techniques......................6... -
Page 5: Introduction
Internet access privileges. Use this Quick-Start Guide to help you configure your new InterServe Firewall and its Eagle NT software. Along with this document, you should refer to the following documents delivered with the... -
Page 6: Getting Started
Intergraph Computer Systems recommends that this interface serve as the internal network interface. Before you can configure your InterServe Firewall and connect it to the Internet, you must have at least one valid Internet Protocol (IP) address and a registered Internet domain name. A valid IP address is one which has been issued to you by an Internet Service Provider (ISP) or by the Internet Network Information Center (InterNIC). -
Page 7: Configuring Windows Nt Server
MB. For instructions on increasing the pagefile size, refer to the operating system documentation and online Help. When installation is complete, install the Windows NT Server 4.0 Service Pack 3 (or higher) software, delivered on CD-ROM with the InterServe Firewall. -
Page 8: Installing And Configuring Eagle Nt
The following steps are described in detail in the Eagle NT Installation Guide and the Eagle NT Configuration Guide; refer to these documents for detailed instructions on completing a specific step. Intergraph Computer Systems recommends that you read these documents before beginning installation and configuration of Eagle NT. -
Page 9: Troubleshooting The Configuration
Troubleshooting the Configuration This section contains answers to frequently asked questions and a list of troubleshooting techniques to help you if you have problems with your Eagle NT configuration. Refer to the Eagle NT Configuration Guide for more information. Frequently Asked Questions Nothing works, what’... -
Page 10: Troubleshooting Techniques
Consult the support section of Raptor’ s Web site at www.raptor.com. If connecting to an outside Web server (for example, www.intergraph.com) does not work from an inside client, try connecting by its IP address. If the IP address works, it is probably a DNS problem. - Page 11 The inside NIC gateway address should be blank. Every inbound and outbound connection at the firewall should be logged. Shut down the Eagle Service on the InterServe Firewall using the command net stop eagle when configuring notifications. When making changes to the Hawk service, always issue the command update, followed by the comand save.
Need help?
Do you have a question about the InterServe Firewall and is the answer not in the manual?
Questions and answers