Intergraph WebScale User Manual page 66

WebScale™
44 WebScale : connection draining started.
45 WebScale : connection draining interrupted.
Warning Event Messages
WebScale generates the following messages for warning events:
Event ID Event Message
13 WebScale : driver temporarily ran out of resources. Increase the
'RegistryParameter' value under
\SYSTEM\CurrentControlSet\Services\WebScale\Parameters key in the
registry.
15 WebScale : dedicated IP address 'XXX.XXX.XXX.XXX' is invalid. Will
proceed assuming that there is no dedicated IP address. Please check
WebScale Setup page and make sure that it consists of four decimal byte
values separated by dots.
18 WebScale : duplicate cluster subnets detected. The network may have been
inadvertently partitioned.
19 WebScale : could not allocate additional connection descriptors. Increase
the 'RegistryParameter' value under
\SYSTEM\CurrentControlSet\Services\WebScale\Parameters key in the
registry.
20 WebScale : port rules with duplicate single host priority 'N' detected on the
network. Please check WebScale Setup dialog on all hosts that belong to
the cluster and make sure that they do not contain single host rules with
duplicate priorities for the same port range.
22 WebScale : there are more port rules defined than you are licensed to use.
Some rules will be disabled. Please check WebScale Setup dialog to ensure
that you are using the proper number of rules.
25 WebScale : port 'N' not found in any of the valid port rules.
26
WebScale : port rules cannot be enabled/disabled while cluster operations
are stopped.
30 WebScale : dedicated network mask 'XXX.XXX.XXX.XXX' is invalid. Will
ignore dedicated IP address and network mask. Please check WebScale
Setup page and make sure that it consists of four decimal byte values
separated by dots.
32 WebScale : both dedicated IP address and network mask have to be
entered. Will ignore dedicated IP address and network mask.
33 WebScale : remote control request rejected from host 'XXX.XXX.XXX.XXX'
due to incorrect password.
37 WebScale : version mismatch between the driver and control programs.
Please make sure that you are running the same version.
Error Event Messages
WebScale generates the following messages for error events:
62
User's Guide