Intergraph WebScale User Manual page 61

WebScale™
reload
(local only)
display
(local only)
ip2mac <cluster>
Examples:
webscale help
webscale query
mycluster
webscale stop
prior to stopping cluster mode.
Converged as default: The cluster has converged,
and the responding host is the current default host,
that is, it is the highest priority host without a
drainstop command in progress. The default
host also handles network traffic for all of the
TCP/UDP ports not covered by the port rules.
Converged: The cluster has converged, and the
responding host is not the default host.
WebScale's current parameters are read from the
Windows NT registry. Cluster operations on the local
host are automatically stopped and restarted if
necessary. If an error exists in the parameters, the host
will not join the cluster, and a warning will be
displayed. In this case, run the WebScale Setup dialog
to fix the problem.
Displays extensive information about your current
WebScale parameters, cluster state and past cluster
activity. The last several event log records produced
by WebScale are shown, including the binary data
attached to those records. This command is designed
to assist in technical support and debugging.
Displays the MAC addresses corresponding to the
specified cluster name or IP address. If multicast
support is enabled, the multicast MAC address will be
used by WebScale for cluster operations; otherwise, the
unicast MAC address will be used. This command is
useful for creating a static ARP entry in the router if
necessary.
returns help information
query status of all hosts in mycluster
stops cluster operations for the local
cluster host
57
User's Guide