Intergraph WebScale User Manual page 59

WebScale™
207.170.198.25:207.170.198.25
mycluster:207.170.198.25
mycluster:1
mycluster:0
mycluster
Cluster Control Commands
The following table describes the commands provided by the WebScale control
program. Note that some commands can only be invoked on the cluster hosts; they are
designated as "local only" in the table.
Argument
help
setup
(local only)
start
stop
drainstop
enable
Action
Displays WebScale on-line help information if
available on the local system.
Invokes the WebScale Setup dialog. This action has
the same effect as clicking the Properties button in the
Network dialog after selecting WebScale Virtual NIC
in the list of network adapters. However, the network
address and multicast support cannot be changed when
the dialog is invoked from the WebScale control
program.
Starts cluster operations on the specified host(s), which
attempt to join the cluster. Enables all ports that may
have been previously disabled.
Stops cluster operations on the specified host(s), which
leave the cluster.
Disables all new traffic handling on the specified
host(s), which enter "draining" mode to complete
existing connections. While draining, hosts remain in
the cluster and stop their cluster operations when there
are no more active connections. Draining mode can be
terminated by explicitly stopping cluster mode with the
stop command. or by re-starting new traffic handling
with the start command.
Enables traffic handling for the rule whose port range
55
- IP addresses
- mix of name and address
- host 1 in mycluster
- default host in mycluster
- all hosts in mycluster
User's Guide