Intergraph WebScale User Manual page 51

WebScale™
æ
Click on the Apply button to enable the new WebScale features encoded in the
license key.
æ
Modify the WebScale parameters as desired.
æ
Click on the OK button to complete the dialog.
æ
Restart cluster operations for this host by running the webscale reload
command. (Please refer to the Cluster Control section for more information on
these commands.)
Disabling and Removing WebScale
You can easily disable the WebScale driver if you will not be using a host in cluster
operations for an extended period of time. To disable the WebScale driver:
æ
Start the Windows NT Network setup dialog as you did when installing WebScale.
æ
Select the Bindings tab.
æ
Select the bindings for the topic all protocols in the drop down list next to the
Show Bindings for: label.
æ
Disable the binding from the WebScale Driver protocol to the network adapter.
æ
Disable the binding from the TCP/IP and the WINS Client protocols to the
WebScale Virtual NIC adapter.
æ Enable the binding from the TCP/IP and the WINS Client protocols to the cluster
adapter if you are using multiple adapters and if you plan to use this adapter to
handle TCP/IP and WINS Client traffic.
æ
Click on the OK button to complete the dialog.
To fully remove the WebScale software, repeat the following steps for every host on
which you have installed WebScale:
æ
Start the Windows NT Network setup dialog as you did when installing WebScale.
æ
Select the Adapters tab.
æ
Highlight the WebScale Virtual NIC adapter.
æ
Click on the Remove button to remove the software.
æ
Examine and modify the bindings from the TCP/IP and WINS Client protocols to
the cluster adapter as desired.
47
User's Guide