(Program); Using A Program - Sharp AR-M351N Operation Manual

SPECIAL FUNCTIONS
PROGRAMMING

(PROGRAM)

This function allows you to store the steps of an operation, including the destination and scanning settings, into a
program. When you want to send a document to that destination, you can simply call up the program and the steps
will be performed automatically. This function is convenient when you frequently send documents, such as a daily
report, to the same destination. Up to eight programs can be stored.
Programs can be stored using the custom settings, and a name up to 18 characters long can be assigned.
For information on storing, editing, and deleting programs, refer to
The following settings can be stored in a program:
Destination address
2in1
Only one-touch and group keys can be used to store the destination addresses. An address cannot be entered
manually. When storing a broadcast transmission in a program, up to 500 destination address can be stored.
NOTES
A program differs from a timer transmission
takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however,
that programs do not allow you to establish a timer setting for transmission.
Internet-Fax reception operations cannot be stored in a program.

USING A PROGRAM

1
In scanner mode, load the document.
2
Touch the [SPECIAL MODES] key and
then the [PROGRAM] key.
ADDRESS REVIEW
SPECIAL MODES
SPECIAL MODES
PROGRAM
FILE
QUICK FILE
TIMER
3
Touch the program key you wish to
execute. Make sure the key is highlighted
and then touch the [OK] key.
OK
G.
RAM1
FREQUENTLY
Resolution and exposure
Card shot
(page 27) in that it is not cleared from memory after transmission
If you are going to use Dual
Page Scan (page 26) and
card shot (page 29), place
the document on the
document glass.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 11).
The program key you
touched is selected and
you return to the screen
of step 2.
The [PROGRAM] key is
highlighted.
33
USED
pages 47 and 48.
Erase Dual Page Scan
4
Touch the [OK] key.
SPEAKER RESEND
OK
DUAL PAGE
SCAN
5
If needed, set the original size and other
settings, and then press the [START] key.
Transmission takes place according to the
program.
NOTE
Select functions that cannot be stored in a program
before you press the [START] key in step 5. These
functions include specifying the original size (See
"MANUALLY SETTING THE SCANNING SIZE" on
page 20.), two-sided scanning (See "SCANNING
AND TRANSMITTING A TWO-SIDED ORIGINAL
(when using B/W scanner module/DSPF)" on
19.), and timer transmission.
TRANSMISSION" on page
OPERATIONS
You will return to the
initial screen.
page
(See "TIMER
27.)