Sharp AR-M351N Operation Manual page 19

6
Touch the desired destination key.
tanaka
tanaka a tana
tanaka b tana
tanaka c
tana
destination to the address book by touching the
[REGISTER] key.
7
Select the destination type.
TO CC
tanaka
tanaka a tana
tanaka b
tana
NOTE
"BCC" can be set only if "ENABLE BCC" of the key
operator program, "BCC Setting", is set.
8
If you wish to enter another address,
repeat steps 6 and 7.
For Scan to FTP and Scan to Desktop, multiple
destinations cannot be specified.
9
Touch the [CONDITION SETTINGS] key.
CONDITION
SETTINGS
DETAIL
ADDRESS REVIEW
sbc.c
SEARCH AGAIN
sbc.c
Address review
transmission
1
Touch the [ADDRESS REVIEW] key and
check the destinations.
E-MAIL/FTP
ADDRESS BOOK
MODE SWITCH
ADDRESS REVIEW
SPECIAL MODES
ADDRESS ENTRY FILE
SEND SETTINGS
QUICK FILE
If you need to clear a destination, touch its key.
To display the remaining
destinations, touch the
[ ] key.
For detailed information
on the selected
destination, touch the
[DETAIL] key. You can
also register the
Normally touch the [TO]
key. However, if you are
performing a broadcast
transmission and wish to
"CC" or "BCC" the
document to the entered
address, touch the [CC]
or [BCC] key.
(page 56)
You will return to the
condition setting screen.
for broadcast
When the [ADDRESS
REVIEW] key is touched,
only the entered
destinations are displayed.
You can also display the
CC and BCC
destinations by touching
the relevant keys.
18
Touch the [OK] key to return to the initial screen.
NOTE
When you perform a broadcast transmission, the
compression mode set with the key operator
program, "Compression mode at broadcasting"
(page 56), is used as the file compression mode for
all destinations.The default setting is "MMR (G4)".
Checking a broadcast transmission
job result and retransmitting an
error job
The results of a broadcast transmission can be
viewed in the following screen, which is opened by
touching the [BROADCAST XXXX] key (where
"XXXX" is the number of the job; see "NOTES" on
page 15) in the finished job screen and then the
[DETAIL] key.
DETAIL OF
BROADCAST XXXX
START TIME
ADDRESS
HQ ADMIN. DEPT.
002 10:01 11/01
SENDAI BRANCH 10:10 11/01
010
FILE
A
A [FILE] tab
This tab is displayed only if the job is stored with the
filing function. If the job is stored, you can
retransmit the same images without scanning the
originals. To retransmit, switch the screen to the
[FAILED] tab or the [ALL DESTINATIONS] tab.
B [FAILED] tab
Among selected destinations for a broadcast
transmission, the destination name, start time, and
transmission status for error transmission are
displayed. You can perform retransmission for the
destinations for which a transmission error
occurred by touching the [RETRY] key.
C [ALL DESTINATIONS] tab
The destination name, start time, and transmission
status for all selected destinations for a broadcast
transmission are displayed. You can perform
retransmission for all the destinations by touching
the [RETRY] key.
SENDING AN IMAGE
OK
STATUS
RETRY
1/ 1
NG000000
NG000000
FAILED ALL DESTINATIONS
B C