Scanning Settings (Original Size, Exposure, Resolution, And File Format); Manually Setting The Scanning Size - Sharp AR-M351N Operation Manual

SCANNING
EXPOSURE, RESOLUTION, AND FILE FORMAT)
When sending an image, you can adjust the original size, exposure, resolution, and file format settings as needed.

MANUALLY SETTING THE SCANNING SIZE

If you load an original that is not a standard size (such as an AB size), or if you wish to change the scanning size,
touch the [ORIGINAL] key and set the original size manually.
Perform the following steps after loading the document in the automatic document feeder or on the document glass.
NOTE
Standard sizes that can be detected are as follows:
A3, B4, A4, A4R, B5, B5R, A5 (11"x17", 8-1/2"x14", 8-1/2"x11", 8-1/2"x11"R, 5-1/2"x8-1/2")
If a non-standard size original is loaded (including special sizes), the closest standard size may be displayed, or
the original size may not appear at all.
1
Touch the [ORIGINAL] key.
300 x 300dpi
RESOLUTION
PDF MMR(G4)
FILE FORMAT
AUTO A4
ORIGINAL
2
Touch the [SCAN SIZE] key.
SCAN SIZE SEND SIZE
100%
AUTO
AUTO A4
2-SIDED 2-SIDED
BOOKLET
TABLET
NOTE
If you wish to rotate the original 90° when creating an
image file, touch the "ROTATE THE IMAGE 90
DEGREES" checkbox (a checkmark should appear
in the box). (only in the E-MAIL/FTP mode)
3
Touch the desired original size key.
OK
A5 A4
AB
A5R A4R
INCH
B4
B5
B5R A3 LONG SIZE
STANDARD SIZE SIZE INPUT
SETTINGS
The sizes that can be
selected are displayed.
*If a B/W scanner
module/SPF is installed,
the [2-SIDED] keys are
not displayed.
[AUTO] is no longer
highlighted. [MANUAL]
and the original size key
you touched are
highlighted.
20
(ORIGINAL
If you wish to select an inch size, touch the
[INCH] key and then touch the desired
original size key.
OK
5 1 8 1 8 1 13
X X
2 2 2
AB
5 1 8 R 1 8 1 14
X
X
2
2 2
INCH
1
8 11
X 11 17
X
2
1 LONG SIZE
8 11R
X
2
STANDARD SIZE SIZE INPUT
If you wish to select a custom size, touch
the [SIZE INPUT] key and enter the size of
the original
MANUAL
AUTO
(64 432)
420
X
MANUAL
mm
(64 297)
Y 297
mm
CUSTOM
SIZE
STANDARD SIZE SIZE INPUT
(2-1/2" to 17") in the X direction and 64 to 297 mm
(2-1/2" to 11-5/8") in the Y direction, set in
increments of 1 mm (1/8").
When using the automatic document
feeder, a setting for originals longer than
432 mm (17") (800 mm (31-1/2") at the
maximum) is available. In this case, touch
the [LONG SIZE] key.
OK
A5
A4
AB
A5R A4R
INCH
B5 B4
B5R A3 LONG SIZE
STANDARD SIZE SIZE INPUT
SIZE,
[INCH] is highlighted
and inch size keys are
displayed.
To return to the AB
palette, touch the [AB]
key once again.
Touch the [X] key and
use the or keys
to set the length in the X
direction, and then touch
the [Y] key and do the
same for the Y direction.
The length can be within
the range 64 to 432 mm