Getting Ready; Making Connections; Connecting Your Monitor Amp Or Mixer Etc. To The Output Jacks; Connecting Your Audio Device To The Input Jack(S) - Korg microSAMPLER Owner's Manual

Making connections

The illustration below shows some typical connections for the microSAM-
PLER.
Computer
USB
to AC outlet
MIDI IN MIDI OUT
AC adapter
(included)
MIDI keyboard, sound
module, rhythm machine,
etc.
Turn off the power before you make connections. Careless operation may
damage your speaker system or cause malfunctions.

Getting ready

1. Connecting your monitor amp or mixer etc. to the
output jacks
Connect the microSAMPLER's OUTPUT [L/MONO], [R] jacks to the
INPUT jacks of your mixer or powered monitors.
If you're using a monaural connection, connect the OUTPUT [L/MONO]
jack.
Mic

2. Connecting your audio device to the input jack(s)

If you want to sample the sound from an audio device or rhythm machine,
connect your device's OUTPUT jacks to the AUDIO IN [L/MONO], [R]
jacks, and set the AUDIO IN [
(☞p.12).

3. Connecting the mic

A mic is included with the microSAMPLER.
To attach the mic, connect it to the front panel AUDIO IN [
tor.
If you want to use a mic to sample your voice, connect the mic to the AUDIO
Headphones
IN [
" " position (☞p.12).
When disconnecting the mic, grasp its connector and pull it out.
Do not use excessive force when connecting or disconnecting the mic.
Monitor speakers
Do not apply excessive force to the gooseneck of the mic.
(with built-in amplifier)
Be aware of the mic's output level when making connections.

4. Connecting your MIDI equipment and/or computer

Make these connections if you want to use the microSAMPLER's keyboard
or controllers to control an external MIDI sound module, or if you want to
use another MIDI keyboard or sequencer to play the microSAMPLER's
sounds (☞p.42 "Using the microSAMPLER with other MIDI devices").
/LINE] switch to the "LINE" position
MIC] jack, and set the rear panel AUDIO IN [
MIC] connec-
/LINE] switch to the
13