Effect Parameters - Korg microSAMPLER Owner's Manual

[Parameter name] : This is a parameter that can be assigned to a front
panel knob. (☞p.36 "2. Controlling effect parame-
ters")
1. COMPRESR (Stereo Compressor)
This effect compresses the input signal to make it more consistent and give it
more punch. It is particularly good for sounds with a strong attack.
You can link the left and right channels, or make them operate indepen-
dently if desired.
Wet: Stereo In - Stereo Out
Left
Envelope - Control
Envelope - Control
Envelope Select
Right
DRY/WET .............................................................. [DRY, 99:1...1:99, WET]
Adjusts the balance between the effect sound and the direct sound.
ENV SEL (Envelope Select) ............................................. [LR MIX, LR INDIV]
With the "LR MIX" setting, the left and right channels will be linked, and the
envelope of the mixed left and right signals will be used to control both
simultaneously.
With the "LR INDIV" setting, the left and right channels will be controlled
independently.

Effect parameters

Dry / Wet
Compressor
Output Level
Output Level
Compressor
Dry / Wet
SENS (Sensitivity) ........................................................................ [1...127]
Adjusts the sensitivity of the compressor. Increasing this value will cause
lower-level sounds to be boosted. Since raising the SENS value will increase
the overall volume, use OUT.LEVEL to adjust the final volume.
Wet
Dry
ATTACK ............................................................................. [0.1...500.0 ms]
Adjusts the strength of the compressor's attack.
Attack=1.0ms
Attack=400ms
Dry
OUT.LEVEL (Output Level) ............................................................... [0...127]
Adjusts the output level of the compressor.
Compressor - Sensitivity
Sensitivity=100
Sensitivity=40
Compressor - Attack
Wet
47